4.6 (223) · € 22.00 · En Stock
Ender 3 not extruding enough, skipping parts of lines, print not sticking to bed, very fragile print. Filament is silver hatchbox PLA. Extruder temp 200, bed 55. Printed great with extact same
Underextrusion?? : r/FixMyPrint
Asa Underextrusion : r/FixMyPrint
Underextrusion with sunlu filament? : r/FixMyPrint
Underextrusion or bad Z offset? : r/ender3v2
Is this under extrusion? : r/BambuLab
What is causing all those bumps, under extrusion and ringing? White was printed 3 months ago, green was before tightening belts, and red is after. : r/FixMyPrint
What causes this underextrusion after the z seam. I have tried changing retraction and temp for the top one but hardly any result : r/FixMyPrint
Violent underextrusion - Believed to be heat creep but very unsure : r/ FixMyPrint
Sunlu S9 Plus - Each side is progressively worse than the last. 60mm/s Hatchbox PLA @200c bed 65c. I have checked belts and carriage rollers to the best of my ability they