5 (473) · € 29.00 · En Stock
I have this DHT22 sensor: It is a white case on a red board which has DAT, VCC and GND connections. Also to the left side it is labeled as AM2302 DHT22 sensor and on the right side it says 1400C80 In the sketch I am using, it says to Connect a 10K resistor from pin 2 (data) to pin 1 (power) of the sensor Is it necessary and if so will it give data readings, as presently it just gives 00% humidity and 0.0C temperature. Thanks
DHT22 / AM2302 sensor driver library available? - Netduino Development - Community
Arduino DUE + DHT22 wrong value - Sensors - Arduino Forum
Peg Box with Temperature and Humidity Monitor, Arduino
DHT22 sensor failures, why? - Sensors - Arduino Forum
troubleshoot DHT22 Humidity sensor - Sensors - Arduino Forum
Display Temperature and Humidity on OLED using DHT22 and Arduino
Test DHT22 Sensors with Arduino and MATLAB
AOSONG DHT22 Temperature Humidity Sensor - ElectroPeak
DHT22 Shows wrong values how do I address this? - #16 by michinyon - Sensors - Arduino Forum