Link 1 down while connecting Orange PI to Pixhawk - Companion
5 (351) · € 14.50 · En Stock
Hi everyone, I’m trying to connect my Orange PI 3 to Pixhawk with telemetry. I make the connection below: I also enable the uart from the config file according to user mauel of the Orange PI and my UART3 port is active: When I run “mavproxy.py” in the command line I’m getting the output below: Auto-detected serial ports are: /dev/ttyS0 /dev/ttyS1 /dev/ttyS2 /dev/ttyS3 /dev/ttyS4 /dev/ttyS5 Those ports are exist but only the ttyS0 and ttyS3 active. My connections are true, I even tried
Connecting Raspberry Pi w/ Pixhawk and Communicating via MAVLink
XBStation 4G Drone Kit
PX4 Community Q&A: July 12, 2023 - PX4 Autopilot Coordination
Connect a Raspberry Pi to a Pixhawk (mav link 1 down problem
6. Install and setup mavlink-router (connecting drone to ground
Wire raspberry pi to pixhawk - Discussions - diydrones
I want to communicate to pixhawk from Raspberry pi 3 and read the
Autonomous Drone Using RPi : 9 Steps - Instructables
6. Install and setup mavlink-router (connecting drone to ground
Sensors, Free Full-Text
6. Install and setup mavlink-router (connecting drone to ground
